<< Back to The Fence Buddy Home Page

Contact Double G Outfitters, the makers of The Fence Buddy
Call Toll free 1-888-434-3254 or E-mail

How To Use The Fence Buddy:

1. Remove the existing clip from the wire and post.
2. Position "The Fence Buddy" from behind post.
3. Push face of "The Fence Buddy" forward and hold wire behind self capturing device on horizontal legs.
4. Pull back and encase wire with "The Fence Buddy".
5. Grab the wire on each end of "The Fence Buddy" and push or pull wire away from post, move wire to desired position and release.
6. To lock The Fence Buddy in position, use wood pegs provided between the inside of The Fence Buddy and the t-post.

CAUTION : May have sharp edges. Always wear gloves when using The Fence Buddy. Make sure The Fence Buddy is secure. Use caution when crossing the fence as wire may snap back towards original position if not properly secured

Frequently Asked Questions

How is "THE FENCE BUDDY" quiet?
Nylon wear pads attach to “THE FENCE BUDDY”’s legs that reduce friction and quiet the sliding action against the post.

How does "THE FENCE BUDDY" work on electric fences?
An insulating tube, provided upon request, is wrapped around the wire then slid through "THE FENCE BUDDY'S" wire capturing loops, insulating "THE FENCE BUDDY" from the electric charge.

Does "THE FENCE BUDDY" work with wooden posts?
At this time Double G Outfitters Inc. is redesigning "THE FENCE BUDDY" to be used on wooden posts. Expect the new design to be out by the end of the year.